IPOffice Parameters¶
For the TotalviewIPOffice to be able to communicate with IPOffice, a service user (application user) with One-X CTI API rights and Management API read/write rights must be created on the IPOffice system.
Since IPOffice version 11.0.4.4 the service user must also have the WebServices.ConfigWriteAll for Groups rights.
Server address |
DNS or IP of the One-X Portal service. |
OneX Port |
The One-X Portal service port to use. Default is 9443. |
Management Port |
The IPOffice management service port to use. Default is 7070 |
IPOffice service user |
Username of the service use with the One-X CTI API and Management API user rights assigned. |
Password |
The IPOffice service user password |
Application version |
Current IPOffice application version. |
International prefix |
Usually 00. For example 0045xxxx Denmark and 00298xxxx Faroe Islands. |
International code |
Country code. For example 45 for Denmark and 298 for Faroe Islands |
Local start/end |
Fill in the first and last local number in the connected IPOffice system. All numbers that are not in the interval are treated as external numbers |
Incoming Trunk Code |
Depending on the PBX setup, external incoming A-numbers may or may not have a preceding digit (usually 0). If this is the case, this digit should be defined here so that the incoming numbers can be interpreted correctly |
Outgoing Trunk Code |
The trunk code required for external calls. |
Behavior configuration¶
Group filter |
Add a filter to only see groups of interest. If empty then no filtering is added. It’s possible to add an interval of group id’s or individual id’s, e.g. 4000,4010-4020 |